Skip to main content

 

Eptura Knowledge Center

Paxton Net2 - Proxyclick Client Setup

  1. Last updated
  2. Save as PDF
  1. Ensure the Paxton Net2 configuration is finalized
  2. Follow the installation and networking steps in the Access Control Overview - Deployment Requirements and Client Setup sections.
  3. Install the Proxyclick Net2 Client and connect to Paxton Net2

  • A local installation will work automatically and you can connect the Proxyclick Client by entering "local host" in the Net2 Location box.

  • If installing the client to a different PC, not running Net2, you will need to install the Net2 SDK on the remote machine then also install the Proxyclick Net2 Client software. You then enter the Hostname or IP of the Net2 Server in the Net2 Location box.

  1. The client should display successful, green, entries for both the connection to Net2 and also under the Network section - If any red entries are displayed you will need to diagnose the cause of the problem before you proceed.
  2. Once only green entries are displayed, Share the Subscription ID and Thumbprint displayed in the access client with the Proxyclick team
  3. To be executed by Proxyclick staff: Gather required setup information - should be shared in advance - we will use this info to ensure the setup matches your requirements
  4. To be executed by Proxyclick staff: Configure the Proxyclick to ACS setup and create access levels
  5. Ensure the created access levels are set up with the correct access permissions for the visitor flows.