Skip to main content

 

Eptura Knowledge Center

On Guard - Proxyclick Client Setup

  1. Ensure the OnGuard configuration is finalized.
  2. Follow the installation and networking steps in the Access Control Overview - Deployment Requirements and Client Setup sections.
  3. Install the Proxyclick OnGuard Access Client and connect to OnGuard.
  4. The client should display successful, green, entries for both the connection to OnGuard and also under the Network section - If any red entries are displayed you will need to diagnose the cause of the problem before you proceed.
  5. Once only green entries are displayed, Share the Subscription ID and Thumbprint displayed in the access client with the Proxyclick team.
  6. To be executed by Proxyclick staff: Gather required setup information - should be shared in advance - we will use this info to ensure the setup matches your requirements.
  7. To be executed by Proxyclick staff: Configure the Proxyclick to ACS setup and create access levels.
  8. Ensure the created access levels are set up with the correct access permissions for the visitor flows.