Skip to main content

 

Eptura Knowledge Center

IBC Setup Guide

  1. Last updated
  2. Save as PDF

This documentation is designed to be a guide in the configuration of the Qscan range of readers by manufacturer IBC (International Barcodes), to make the process easier when integrating an access control system into the Proxyclick visitor management experience.

This guide is only designed to assist in the configuration of reading the Proxyclick QR code format, not to provide a comprehensive detailing of all of the Qscan reader range functionality.

Qscan models supported by this process:

Qscan: http://www.internationalbarcode.com/qscan.htm
Qscan (Indoor Version): http://www.internationalbarcode.com/qscani.htm
Qscan Mini: http://www.internationalbarcode.com/qscanmini.htm
QscanT: http://www.internationalbarcode.com/qscant.htm

For further information on the Qscan reader range functionality, the product manual can be found here: http://www.internationalbarcode.com/manuals.htm.

Configuration QR codes

Use the below QR codes with a new Qscan reader - if your reader has already been set up you may need to reset prior to continuing with the below process.

The following QR codes allow for a simple setup, enabling the reader to read Proxyclick QR codes with either a 37 or 42 bit Wiegand output.

We have found that the below configuration QR codes need to be printed out to successfully work with a new reader. Once they have been used, the reader will have "mobile mode" activated so they will then successfully read QR codes from a mobile screen.

37 bit output

The below QR code will configure the Qscan reader to:

  1. Read the first 8 digits of the QR code only (where we place our token numbers)
  2. Output as HID 37bit large format (1 parity + 35 data + 1 parity)
  • 37 bit output configuration QR

 

42 bit output

The below QR code will configure the Qscan reader to:

  1. Read the first 8 digits of the QR code only (where we place our token numbers)
  2. Output as HID 42bit large format (1 parity + 40 data + 1 parity)
  • 42 bit output configuration QR

 

Use the below barcode to return readers to factory default settings (may not function if a lockout barcode has already been presented to the reader):

  • Reset Barcode