Gallagher Command Center - Proxyclick Client Setup

Ensure the Gallagher Command Center configuration is finalized.
Follow the installation and networking steps in the Access Control Overview - Deployment Requirements and Client Setup.
Install the Proxyclick Gallagher Client and connect to Gallagher Command Centre - A local installation is possible and you can connect the Proxyclick Client by entering "local host" and the port in the Gallagher Location box. Example: https://localhost:8904 - If installing the client to a different PC, you enter the Hostname or IP of the Gallagher Server and the port in the Gallagher Location box.
On the "Connection settings" tab you will also enter the API key for the REST client you created during setup.
The client should display successful, green, entries for both the connection to Gallagher and also under the Network section - If any red entries are displayed you will need to diagnose the cause of the problem before you proceed.
After only green entries are displayed, Share the Subscription ID and Thumbprint displayed in the access client with the access control team
To be executed by Proxyclick staff: Gather required setup information - should be shared in advance - we will use this info to ensure the setup matches your requirements.
To be executed by Proxyclick staff: Configure the Proxyclick to ACS setup.
Ensure the created access groups are set up with the correct access permissions for the visitor flows.