Skip to main content

 

Eptura Knowledge Center

C•CURE 9000 - Proxyclick Client Setup

  1. Last updated
  2. Save as PDF
  1. Ensure the C•CURE configuration is finalized
  2. Follow the installation and networking steps in the Access Control Overview Deployment Requirements and Client Setup sections.
  3. Install the Proxyclick C•CURE 9000 Access Client and connect to C•CURE 9000
  4. The client should display successful, green, entries for both the connection to C•CURE 9000 and also under the Network section - If any red entries are displayed you will need to diagnose the cause of the problem before you proceed.
  5. Once only green entries are displayed, Share the Subscription ID and Thumbprint displayed in the access client with the Proxyclick team
  6. To be executed by Proxyclick staff: Gather required setup information - should be shared in advance - we will use this info to ensure the setup matches your requirements
  7. To be executed by Proxyclick staff: Configure the Proxyclick to ACS setup and create access levels
  8. Ensure the created clearances are set up with the correct access permissions for the visitor flows.

You can install the Proxyclick client on the same server as the Victor Web Service.