Skip to main content

 

Eptura Knowledge Center

Galaxy - Eptura Visitor Client Setup

Before you start


Eptura Visitor client setup for Galaxy


Follow the steps below to set up the Eptura Visitor client.

  1. Install the Eptura Visitor Galaxy Client and connect to Galaxy. 
    Local installation: If a local installation is preferred, connect the Eptura Visitor Client by entering 'local host' and the port in the Galaxy URL box. Example: https://localhost:8000. If installing the client to a different PC, enter the Hostname or IP of the Galaxy Server, and the port, in the Galaxy Location box.
  2. Enter the Galaxy Admin username and password.
  3. Enter your Company name on the 'Connections settings' tab.
  4. Check the connections to both Galaxy and the Network are successful:
    1. Successful (green): Ensure the Eptura Visitor client displays green for both the connection to Galaxy and under the Network section, before continuing.
    2. Unsuccessful (red): If any red entries are displayed, diagnose the cause of the problem before continuing.
  5. Share the Subscription ID and Thumbprint displayed in the Eptura Visitor client with your Eptura Visitor/Eptura contact.

The Eptura Visitor team now configure the Eptura Visitor to ACS setup.

  1. When the Eptura Visitor team have completed the Eptura Visitor to ACS setup, ensure the created access levels are set up with the correct access permissions for the visitor flows.